T&O 4 Flute SuperCEED Solid Carbide TiCN Coated Finishing Single End Mill, 7/16″ Size, 7/16″ Shank Diameter, 1″ Length of Cut, 2-3/4″ Overall Length

• Restricted heat conductivity.
• Increased cutting speed.
• Chip Formation Improved
• Lower friction, higher flow speed.
• Reduced chip compression/cutting forces.
• Extension Of Tool Performance
• High hardness protects against abrasive wear.
• High chemical stability prevents built-up edge, micro cracks and crater wear.
• Increase in tool life.
• Center Cutting
• Cutting Direction: Right Hand
• Helix Angle: 30
• Tolerance_Cutting Diameter: -.0005″ / -.0015″
• Tolerance_Shank Diameter: -.0001″ / -.0005″
• Workpiece Material Range: Steel, Stainless Steel, High-Temp Exotic Alloys, Cast Iron, Hard Materials
• When under conditions of moderate cutting temperatures, TiCN is harder and more wear resistant than TiN.
• It also provides 50% more spindle speed compared to TiN, especially in stainless steels.
• There is a tendency to gall on non-ferrous materials so please use caution.
• TiCN also requires an increase of 35% to 50% in machining speeds vs. uncoated tools.

For More T&O 4 Flute SuperCEED Solid Carbide Coated Finishing Single End Mills Click Here