Starrett 568C V-Blocks and Clamps

Starrett V-Blocks come in a variety of styles to suit the numerous requirements of machinists. They are for general shop use and layout work, as well as for holding stock in place during light-duty milling, drilling, and grinding operations. All clamp screws have a hole to help secure the workpiece. V-Blocks (2) and Clamps (Matched Pair).

Features:

• Hardened steel, precision ground parallel and square
• V-grooves are ground central and parallel to the sides and base – perfect alignment in matched pairs
• Clamps have screw holes at 45 and 90 to hold either square or round work
• Stepped groove construction permits high or low clamp mounting or small or large work
• Clamps do not project over the width of the block, permitting it to be used on the base, ends or sides
• 3/8-16 tapped holes permit mounting blocks on faceplates or angle irons
• Each block is 2-1/2″ long x 3″ wide x 2″ high (63 x 75 x 50mm)

Specifications:

• Capacity (in): 2″ Dia. Round; 1-7/16″ Square (1-9/16″ with Screw at Top)
• Capacity (mm): 50mm Dia. Round; 36mm Square (40mm with Screw at Top)