Suburban Round Magnetic Chuck, Standard Pole, 6-1/4″ dia. – RMC-6

• Made in U.S.A.
• For efficient holding of magnetic work pieces on grinders, lathes, and other machines with rotating spindles.
• Permanent, ceramic magnets provide superior holding power that never fades and require no electrical controls or collector rings.
• Thick top plates are laminated from steel and stainless steel, then furnace brazed into one solid piece and precision ground.
• Top plate can be drilled, tapped or machined to three-fourths of its thickness (approx. 5/8″), if necessary, to allow the use of dowel pins or other mechanisms as locating devices.
• Back surface of aluminum chuck body has Tapped Holes (D) and a Turned Counterbore (B) for convenient mounting to your machine.
• “Partial-On” for holding parts prone to distortion.
• Removable on-off handle included with each chuck.
• All models except 5-1/2″ dia (RMC-5) which uses the swing-type on-off method, are sealed against water and other elements.

STANDARD POLE: 1/4″ poles and 1/8″ separators produce deep flux lines for holding large and thick parts. (RMC-15 and RMC-20 have 3/8″ poles and 3/8″ separators).

FINE POLE: 1/8″ poles and 1/8″ separators produce shallow flux lines for holding small and thin parts.

See all Suburban Round Magnetic Chucks